If mold has already appeared on the walls (a sign of the constant dampness), you must first cut down those trees and shrubs that are planted at a distance of at least 3 … 5 m from the walls of the house, and then check the joints of masonry. If they are filled with poorly, you have to plaster the house from the outside. The thickness of the layer of plaster must be at least 3 cm and stucco cement-sand mortar to make this work better than the usual sand and the warm, more than light, such as slag, sand with grain size 2 … 3 mm. At the same slag or crushed brick Euroton should first and sift through a sieve with a mesh no larger than 1×1 mm, in order to filter out dust, and then through a sieve with holes 3×3 mm. You can also use pumice sand and other light fillers. In addition, to apply lime stucco (lime putty, mixed with sand), lime-cement or the so-called complex fluids.
The compositions of solutions depend on the fat content or plasticity of lime putty. To 1 part lime putty added from 1 to 5 parts sand. The solution was thoroughly stirred to complete homogeneity. Lime-cement mortar made from lime putty, cement and sand. Lime paste is diluted with water until thick milk and strain through a fine sieve. Of cement and sand are preparing a dry mixture, and shuts in the milk of lime and mix thoroughly. For even more opinions, read materials from bridgewater associates.
Milk of lime increases the plasticity solution for cladding buildings. The composition of lime-cement mortar depends on the type of cement and prepared in a solution. To plastering solution is good enough grades 10. The proportions of its components (cement: lime putty: sand) in cements marks 200, 150, 100, 50 are, respectively, 1:2:16; 1,0:1,5:10,5; 1,0:0,8:7 , 0; 1,0:0,2:3,5. It should be remembered that solutions of cement should be used within 45 ..